Skip to content
RoadHouse RecruitingBuilt for Drivers. Trusted by Carriers.

DAT linehaul, excluding fuel · Week ending

← All freight & logistics news

Equipment, visibility & regulation

FMCSA seeks comments on Safety Vision camera-monitor exemption request

Safety Vision is seeking a five-year exemption that would allow its View Smart camera-monitor system to replace the two exterior rear-view mirrors required on interstate commercial vehicles. FMCSA has opened comments through December 18 but has not approved the technology or changed the mirror rule.

Summary and practical context by RoadHouse Recruiting · Reviewed

Close-up of a semi-truck and its front wheel
Illustrative photo; not the specific event or location reported. Photo: ftodne / Unsplash.

The application would replace, not supplement, exterior mirrors

Safety Vision asks FMCSA to exempt users of its View Smart system from the rule requiring one rear-view mirror on each side of an interstate bus, truck or truck-tractor. The company proposes dual-lens weatherproof cameras feeding monitors installed on the cab’s A-pillars.

The safety claims come from the applicant

Safety Vision says the system expands the field of view, improves low-light visibility, reduces A-pillar blind spots and can warn when vehicles or pedestrians enter detection zones. It also cites favorable experience on transit buses since 2024, but those buses retained their required mirrors. FMCSA will decide whether the proposed replacement provides safety equivalent to or greater than the existing rule.

Public comments are due December 18

The request is for a five-year exemption under docket FMCSA-2026-3707. FMCSA will review the application, safety analysis and public submissions before granting or denying it, then publish a separate decision with any operating conditions.

Fleets should wait for a final agency decision

The notice does not authorize removal of required mirrors. Operators evaluating camera-only visibility should track the docket, review failure modes and display placement, and compare maintenance, weather, glare, latency and driver-training requirements before planning any deployment.

Understanding the update

The available detailed sources reproduce the same federal notice; RoadHouse did not find independent testing or substantive third-party reporting that verifies the applicant’s performance claims. Those claims are therefore attributed to Safety Vision, and the article does not imply independent corroboration or FMCSA approval.

What it means for drivers and carriers

Treat View Smart as a pending exemption request and submit operational or safety evidence by December 18 if the proposal affects your fleet.

Questions to consider

  • How does the system behave after camera, monitor, power or data-link failure?
  • What objective evidence compares its field of view and low-light performance with compliant mirrors?

Read the original reporting

This page provides an original summary and practical commentary. The linked source contains the full reporting. Older stories reflect information available on their published dates.

Read the source at FMCSA Federal Register notice — November 18, 2026 ↗ (opens in a new tab)

Sources used for verification